fissa 发表于 2012-12-9 02:20

好吧,找机会也去签个名!gochinway06;)

fissa 发表于 2012-12-9 02:20

谷歌翻译:

发动机 - 自然吸气,4缸,线,结构安装,2300cc,16气门考斯沃斯,锻造杆和活塞,干式油底壳内部扫泵,BAC / ITG航空的优化碳入口,远程过滤系统,碳气箱,考斯沃斯/ BAC开发的4-2-1的不锈钢排气管,并集中安装系统,宝石EM40 ECU与考斯沃斯/ BAC开发的校准

最大功率280bhp @ 7700rpm 280Nm的@ 6000RPM

传输 - AP赛车离合器,Hewland FTR六速顺序盒,充分强调了整体油箱,电力潮流的LSD,Shiftec电子/气动半自动操作的闭环系统通过安装在方向盘上拨片,GKN / BAC开发的,低摩擦传动轴

MOTUL使用的液体在整个

悬挂

接待 - 可调节的pushod激活双叉臂系统,滚针轴承安装的钟形曲柄,门,优化外倾角变化和轧辊中心位置,充分阿克曼几何垫片可调整的弯曲度上升

后 - 齿轮箱安装,可调节推杆启动双横臂系统,滚针轴承安装的钟形曲柄,上升率,优化外倾角变化和轧辊中心位置,垫片可调整的弯曲度

TIG焊接,无缝CFS3钢航空管叉骨,超轻,钢坯铝立柱正面和背面,2方式可调高盛赛车RDS阻尼器,36分子式系统,比赛规格ħ&ŕ325磅前和375磅后弹簧,上升率颠簸橡胶,可调前排和后扭杆

单声道建设

超轻型碳纤维/泡沫,TIG焊接CDS管安全小区,RAC MSA&FIA标准的翻滚保护系统,碳纤维碰撞吸能盒,侧面碰撞结构,BAC / FKFS的开发和测试,低阻力空气动力学套件,35ltr定制合金油箱两阶段过滤的的内部挡板和集热器系统,可上锁的铝坯口盖,油箱燃油泵ATL

刹车 - AP赛车,方程式赛车卡钳,径向活塞式,AP赛车游戏295毫米通风碟,交叉钻孔,钢坯加工安装的钟声,AP赛车踏板箱,轴承安装钢坯踏板

HRT合金车轮和轮胎 - OZ赛车/ BAC开发的7.5和8.5 x17in,锦湖/ BAC开发的的V70a 205及245/40 R17

室内装饰(好吧,你坐...) - 蒂利特/ BAC开发的固定位置的碳纤维座椅,在极端的防水皮革修剪,MICROCARE MC防水“Suede的,铝坯BAC290毫米直径方向盘与GEMS LDS4彩色显示系统,16PIN快速释放转向老板,启动按钮,Willans安全约束系统,FIA标准

的范围内,制造商的颜色或颜色的选择有

 

赛车使用 - 座舱可调节的制动偏差,种族规范垫,阻尼器,牵引眼,灭火器额外的RIM组,可见碳板,主杀交换机

护理 - 汽车千斤顶,遥控器的电池充电插座,室内车罩,车罩外墙防水,酒桶形座舱雨盖,跟踪,头盔蓝牙,异形座

fissa 发表于 2012-12-9 02:21

原文:



Engine – Normally aspirated, 4-cylinder, in-line, structurally mounted, 2300cc, 16 valve Cosworth, forged rod and pistons, dry sump with internal scavenge pump, BAC/ITG aero optimized carbon inlet, remote filtration system and carbon airbox, Cosworth/BAC developed 4-2-1 stainless steel exhaust manifold and centrally mounted system, GEMS EM40 Ecu with Cosworth/BAC developed calibration

Max power 280bhp @7700rpm 280Nm @ 6000rpm

Transmission – AP Racing clutch, Hewland FTR six speed sequential box, fully stressed with integral oil tank, Powerflow LSD, Shiftec Electronic/Pneumatic semi-automatic closed loop system operated via steering wheel mounted paddles, GKN/BAC developed low friction driveshafts

Motul fluids used throughout

Suspension

Front – Adjustable pushod activated twin wishbone system with needle roller bearing mounted bell cranks, rising gate, optimized camber change and roll centre position, full Ackermann geometry, shim adjustable camber

Rear – Gearbox mounted, adjustable pushrod activated twin wishbone system with needle roller bearing mounted bell cranks, rising rate, optimised camber change and roll centre position, shim adjustable camber

TIG welded, seamless CFS3 steel aero tube wishbones, Ultra light, billet aluminium uprights front and rear, two way adjustable Sachs Racing RDS dampers, 36 Formula system, Race spec H&R 325lb front and 375lb rear springs, rising rate jounce rubbers, adjustable front and rear torsion bar

Mono construction

Ultra light weight carbon fibre/foam, TIG welded CDS tube safety cell, RAC MSA & FIA compliant roll over protection system, carbon fibre crash box, side impact structure, BAC/FKFS developed and tested low drag aero package, 35ltr custom alloy tank with internal baffles and collector system, lockable billet aluminium filler cap, ATL in tank fuel pump with two stage filtration

Brakes – AP Racing, Formula car caliper, radial 4-piston type, AP Racing 295mm ventilated discs, cross drilled, billet machined mounting bells, AP Racing pedal box, ball bearing mounted billet pedals

Wheels and tyres – OZ Racing/BAC developed HRT alloy 7.5&8.5 x17in, Kumho/BAC developed V70a 205&245/40 R17

Interior (okay, where you sit…) – Tillett/BAC developed fixed position carbon fibre seat, trimmed in Extreme waterproof leather, Microcare MC waterproof ‘suede’, BAC 290mm diameter billet aluminium steering wheel with GEMS LDS4 colour display system, 16pin quick release steering boss, starter button, Willans safety restraint system, FIA compliant

Available in a range of manufacturer colours or a colour of your choice



Available for motorsport use – cockpit adjustable brake bias, race spec pads, dampers, towing eyes, fire extinguisher, additional rim set, visible carbon lower panels, master kill switches

Care – Car jack, remote battery charge socket, indoor car cover, external waterproof car cover, tonneau cockpit rain cover, tracker, helmet bluetooth, profiled seat

蓝色小C 发表于 2012-12-9 12:15

开这车需要带头盔吗……

fissa 发表于 2012-12-9 12:34

蓝色小C 发表于 2012-12-9 12:15 static/image/common/back.gif
开这车需要带头盔吗……

那当然~·

jianggaopeng 发表于 2012-12-9 12:57

gochinway49;)

蓝色小C 发表于 2012-12-10 19:22

泡妞利器·····可是妹子坐哪里???chinway50tiger

fissa 发表于 2012-12-10 19:29

蓝色小C 发表于 2012-12-10 19:22 static/image/common/back.gif
泡妞利器·····可是妹子坐哪里???

趴~

蓝色小C 发表于 2012-12-10 20:41

fissa 发表于 2012-12-10 19:29 static/image/common/back.gif
趴~

chinway45tiger
页: 1 2 3 [4]
查看完整版本: FLYING SOLO,拒绝后座,拒绝副驾,总之,拒绝乘客。。。


速道改装车社区论坛所有帖子仅代表作者本人意见,不代表本网站立场。
转载文章请注明作者及出自"速道性能车改装车网(http://www.chinway.com.cn)",如用于商业用途请联系原作者

拒绝任何人以任何形式在本论坛发表与中华人民共和国法律相抵触的言论!

©2007-2020 速道性能改装车网